-
CY (标准型系列)
通用性较强,手动左右推拉,自动夹持,要有T槽
Strong versatility, manual left-right push-pull, automatic clamping, with T slot
-
CY-C (气缸移动式)
自动推拉夹持,模具要求夹持方式统一(上下夹持或左右夹持),要有T槽
Automatic push-pull clamping, die clamping mode required to be unified (upper and lower clamping or left and right clamping), with T slot
-
CY-Ⅰ (固定式)
适合模具底板统一标准化场所,夹模器不作移动,无需T槽。
It is suitable for the unified standardization of the bottom plate of the die,and the clamping device does not move.No T slot is needed.
-
CY-Ⅱ (导轨式)
适合小吨位机器左右夹持,无需T槽,能在区块内滑移的夹模器,
模具底板宽度差异小于100mm
Suitable for small tonnage machine left and right clamping,without T groove,can slip in the block clamp,the width difference of the bottom plate of the die is less than 100mm.
-
CY-H (耐高温式)
适合高温、粉尘环境中手动左右推拉,夹模器要有T槽,压铸机为主
Suitable for high temperature, dust environment, manual left-right push pull, Clamper damping,T slot, die-casting machine mainly.
-
CX(伸缩式)
适合冲床和立式注塑机使用,手动推拉,自动夹持,
需要模具底板统一标注化,设备需要T型槽
It is suitable for punch press and vertical injection molding machine. It can be pushed and pulled manually and clamped automaticall.The mold base plate should be marked uniformly.The equipment needs T-groove